NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
Relating FTS Catalyst Properties to PerformanceDuring the reporting period June 23, 2011 to August 31, 2013, CAER researchers carried out research in two areas of fundamental importance to the topic of cobalt-based Fischer-Tropsch Synthesis (FTS): promoters and stability. The first area was research into possible substitute promoters that might be used to replace the expensive promoters (e.g., Pt, Re, and Ru) that are commonly used. To that end, three separate investigations were carried out. Due to the strong support interaction of γ-Al2O3 with cobalt, metal promoters are commonly added to commercial FTS catalysts to facilitate the reduction of cobalt oxides and thereby boost active surface cobalt metal sites. To date, the metal promoters examined have been those up to and including Group 11. Because two Group 11 promoters (i.e., Ag and Au) were identified to exhibit positive impacts on conversion, selectivity, or both, research was undertaken to explore metals in Groups 12 - 14. The three metals selected for this purpose were Cd, In, and Sn. At a higher loading of 25%Co on alumina, 1% addition of Cd, In, or Sn was found to-on average-facilitate reduction by promoting a heterogeneous distribution of cobalt consisting of larger lesser interacting cobalt clusters and smaller strongly interacting cobalt species. The lesser interacting species were identified in TPR profiles, where a sharp low temperature peak occurred for the reduction of larger, weakly interacting, CoO species. In XANES, the Cd, In, and Sn promoters were found to exist as oxides, whereas typical promoters (e.g., Re, Ru, Pt) were previously determined to exist in an metallic state in atomic coordination with cobalt. The larger cobalt clusters significantly decreased the active site density relative to the unpromoted 25%Co/Al2O3 catalyst. Decreasing the cobalt loading to 15%Co eliminated the large non-interacting species. The TPR peak for reduction of strongly interacting CoO in the Cd promoted catalyst occurred at a measurably lower temperature than in the unpromoted catalyst. Nevertheless, the Co clusters remained slightly larger, on average, in comparison with the unpromoted 15%Co/Al2O3 reference catalyst. None of the promoted catalysts (i.e., with Cd, In, or Sn) exhibited surface Co0 site densities higher than that of the unpromoted catalyst. In activity testing, the activities were even much lower than what was expected from the H2-TPD results. Two possible explanations were proposed: (1) the promoters may be located on the surfaces of cobalt particles, blocking surface Co0 but being able to desorb hydrogen or (2) the promoters may facilitate Co oxidation during FTS, as previously observed by Huffman and coworkers when K was added to cobalt catalysts.
Document ID
20160008105
Acquisition Source
Glenn Research Center
Document Type
Contractor Report (CR)
Authors
Ma, Wenping
(Kentucky Univ. Lexington, KY, United States)
Ramana Rao Pendyala, Venkat
(Kentucky Univ. Lexington, KY, United States)
Gao, Pei
(Kentucky Univ. Lexington, KY, United States)
Jermwongratanachai, Thani
(Kentucky Univ. Lexington, KY, United States)
Jacobs, Gary
(Kentucky Univ. Lexington, KY, United States)
Davis, Burton H.
(Kentucky Univ. Lexington, KY, United States)
Date Acquired
June 30, 2016
Publication Date
June 1, 2016
Subject Category
Aeronautics (General)
Report/Patent Number
GRC-E-DAA-TN19171
E-19036
NASA/CR-2016-218485
Funding Number(s)
WBS: WBS 473452.02.03.06.07.01
CONTRACT_GRANT: NNX11AI75A
Distribution Limits
Public
Copyright
Public Use Permitted.
Keywords
Zirconia
Fischer-Tropsch
Cobalt Catalyst
No Preview Available